Website design By BotEap.comAchieving a successful installation when it comes to a shower stall is not as difficult as you might think. Given your ability to follow directions and a reasonable amount of construction knowledge, it can be quite rewarding in the end. With quality renovation professionals increasingly delusional and investment sometimes exceeding the budgeted amount, DIY is on the rise.

Website design By BotEap.comYou will need to temporarily turn off the water in the shower unit first, don’t worry, once the pipe is plugged, you can turn it back on. Now remove the shower stall as it is now. Depending on whether or not you have a fiberglass unit, cast iron tub, or existing tile stand, your demonstration method will differ.

Website design By BotEap.comNow that the demo is complete, determine where you want your new shower valves and fittings to go, and discuss them now. Most of the time, when a bathtub has been removed, you will need to install the drain in the center of the new cabin opening. Also common today are shower niches or soap dishes, the placement and framing of these along with any type of knee or pony wall. “is also done now,

Website design By BotEap.comA pre-slope of the slab will now be installed with a castable mud material. Marking into the slab or subfloor the final depth of the new shower stall will give you a stopping point for your pre-slope. ext Install the shower tray liner by attaching it to the drain and pulling it up the wall above your seat height or about 20 inches. Next, form the sidewalk that the shower door will stand at a desirable height, usually 5 inches, with a 2×6 by pulling the tray up between the form boards and pouring on each side with concrete that encapsulates the tray. .

Website design By BotEap.comInstallation of Duroc material or a concrete-based backing board and taping mesh for the joints will now be done. Once done, use a paint or waterproof membrane and cover the entire shower stall except the floor. When dry packing the floor over the shower tray it is very important to keep at least 1/4 inch for every 3 feet of drop into the drain, this will ensure the water drains properly.

Website design By BotEap.comAfter completing this step, you are ready to begin your shower floor tile installation. Once it is dry, you can begin the installation of the siding. After the tile installation is complete, you will need to clean all tiles and grout lines before grouting begins.

Website design By BotEap.comFinally install your new shower door and shower fixtures to start reaping the benefits of your hard work.