Website design By BotEap.comAn automatic screw feeder machine must be used very carefully. Professionals such as repairmen and manufacturers can greatly benefit from these machines. Basically, the choice of these drives is based on whether the professionals are experienced enough to use the drives. In this article, we have given some tips to help you understand how to use these screw feeders the right way.

Website design By BotEap.com1. Inspect Your Assembly Line First

Website design By BotEap.comThese machines can be difficult to install. Therefore, you should first consider the assembly unit at your workplace. Since it will be a long-term investment, be sure to make this decision after careful consideration.

Website design By BotEap.comTherefore, it makes sense to thoroughly inspect your assembly unit before investing in these machines. Also, if you don’t need to drive more than a few screws per day, it may not be a good idea to purchase an automatic screw feeder unit.

Website design By BotEap.comBut if you need to fix hundreds of screws on a daily basis, then you should consider buying one. In this case, buying an automatic screw feeder is a genius, as these units will help you significantly reduce your effort.

Website design By BotEap.com2. Consider the installation location

Website design By BotEap.comTo get the most benefit, be sure to consider the location where the machine will be installed. What you need to do is check the location before installing the machine. The location must be appropriate. In other words, it should not be far from the operator or a place where you cannot easily access it.

Website design By BotEap.com3. Choose a solid foundation

Website design By BotEap.comThe place where you are going to fix the product must be solid enough. Since it is an electronic device, it will also serve as a robot. Therefore, the place under the machine must be rigid. Therefore, make sure that the place is not soft, rough or mobile.

Website design By BotEap.com4. Power connection

Website design By BotEap.comBefore making the power connection, make sure that the unit is properly fixed with the correct accessories. If you leave the unit as it is, it can be dangerous when the power supply is connected. So it makes sense to check the drive before connecting power.

Website design By BotEap.com5. Follow the specifications

Website design By BotEap.comBe sure to choose the specified screws only based on the design of the machine. If you don’t use the correct type of screws, you can end up causing serious damage to the machine.

Website design By BotEap.com6. Keep a safe distance

Website design By BotEap.comWhile using the machine, be sure to keep the proper distance between you and the machine. You must keep your fingers and hands at a safe distance from the unit.

Website design By BotEap.com7. Shut down immediately

Website design By BotEap.comIf the unit does not seem to be working properly for any reason, turn it off immediately and also disconnect the power supply.

Website design By BotEap.com8. Changes

Website design By BotEap.comDo not make the mistake of repairing or damaging any obsolete or damaged part. It is best to leave these tasks to a professional.

Website design By BotEap.comfinal verdict

Website design By BotEap.comTherefore, if you want to use your automatic screw feeder machine in the right way, we suggest that you follow the tips given in this article. This will help your machine stand the test of time and save you a lot of money in the long run.